AG100Pe

Acoustic insulation for laminate with vapor barrier

Reduces the transmission of sound. Improve the sound quality of the laminate flooring. Agglomeration of open-cell polyurethane.

Equipped with a vapor barrier of 150 microns elastic even after long periods of load. Supplied in rolls and easy to install. Improves comfort of walking

Utilization
AG100PE is an acoustic insulation that absorbs the noise from footsteps and one from falling objects. Is, furthermore, reduced the noise of the environments on the lower floors. This acoustic insulation, polyurethane, laminate flooring gives the sound more natural, warm, pleasant, a sound similar to what is found in parquet flooring. Even after long periods of load, are all insured roperties noise and the material retains its flexibility. The insulator has a PE film of 150 microns which acts as a vapor barrier and facilitates installation.
The product can be installed on wood, concrete or wood, and is' able to level uneven surfaces.

Fixing
Use AG100PE film in a dry and protected from moisture during transport.
The under floor must be prepared according to the manufacturer's instructions. Spread the insulating perpendicular to the laminate. The PE film must be facing down. Make sure that about 5 cm of overlap with the wall.
Spread the subsequent roll and make sure it does not overlap with the previous one, and then join them together until they fit together. Fasten them together with duct tape.
Install the laminate flooring.
Remove the pieces of insulation and place the remaining sockets.
Use a flexible coupling, avoiding contact between the base and and laminate flooring.

 * In consequence of the policy of development and improvement of its products, the Multisint reserves the right to change notifying the customer variants of the products used.